Instructions
-
Get in the truck and start it up. Flip the switches on to begin the
mixing process. Today's concrete mixer trucks have a drum in which the
cement is mixed. The drum is rotated by a drive unit. There is a loading
chute located at the top of the mixer. The ingredients will have to be
added to the chute.
-
Pour the concrete into the chute and add the water using the same
method. The ingredients to be mixed are funneled into the drum by way of
the chute. In addition, there is a long chute that can be used to
change the angle, depending on the position of the drum. There are also
paddles located in the drum.
-
Get in the truck and set the drum of the truck to begin rotating. The
drum contains blades that are set at an angle to the axis, located at
the center of the drum. These blades run in a direction of longitude.
There is a hydraulic gear that runs the main engine, thus rotating the
drum. Because the drum is constantly rotating, the mixture of cement and
water turns and rolls in the drum, coating the drum's surface.
-
Engage the truck's transmission to the drive position. Begin driving
to your destination. The mixture will continue to turn and mix until the
cement mixer reaches the desired destination. The paddles will then
push the mixture toward the front of the drum so that the cement can be
extracted when the time comes. When the mixer arrives at its intended
location, the mixture will be ready to pour.
-
Park the truck next to the site where the concrete machinery will be poured.
- Reverse the drum's rotation. Once this is done, the angle of the blades then push the cement toward the opening of the drum. It spills out of the drum and onto the chute. The chute can be pushed towards the intended site, and the concrete is then poured.
没有评论:
发表评论