WHAT ADJUSTMENT SMALL CRUSHER EQUIPMENT BACKLASH STEPS?

Small hard rock crusher equipment is to fight the best equipment, it has been widely applied to various industries. Hangzhou Truemax Machinery & equipment Co., Ltd. as a professional in the development and production of small stone crusher manufacturers, according to the Hangzhou Truemax mechanical engineer years of experience, summed up on small crusher equipment inspection and adjustment flank, tip clearance steps, we want to help.

1, the eccentric sleeve should if possible large gear directly on the top side of the counterweight pinion.

2, with a crowbar or other ways to drive side pulling the pinion, the pinion shaft close to the end face of the thrust bearing sleeve end face of the inside frame. Note: Before measuring, you must loosen the belt or flexible coupling.

3, slightly rotating shaft, until a large gear teeth located in the vertical position.

4, with a jack or pry bar is pressed against the eccentric pinion side, eliminating small crusher equipment eccentric bushing and the clearance rack, so the size of the gear in the most recent position. Preferably horizontal top to pinion jack. Jack force, crowbar only enough force to eliminate the gap, can not skew the eccentric sleeve top.

5, the large gear holding be measured at the position. Should decile three measurement gap values, then averaged. The average shall comply with the provisions of the foregoing.